Back in post #155 I had mentioned that I had dropped my camera and lens onto concrete and they were no longer working. I took it to the repair shop and now, 3 months later, I finally got them back. The lens was repaired but I have no way of testing it as the camera was totaled. The accident was completely my fault and could have easily been prevented. As the equipment would have cost a couple thousand dollars brand new, I will pass on the mistakes I made in hopes of preventing some noobie photographer like myself from making the same mistakes I did.
This is the gear and rough setup that I was using except that I had the legs extended much higher. You may see a big mistake right there.
I kinda knew the basics of tripods, I’ve used them many times but I’ve never given them much thought. I will from now on! Prices on tripods run from twenty dollars to thousands of dollars. You get what you pay for. And you try to pay for what you really need. The basic parts of the tripod are legs, neck, pan & tilt head(most of the cost), base plate, and a quick release plate that screws into the bottom of your camera and then locks/unlocks to the base plate. You can leave it on your camera if you are going to use a tripod a lot.
In this picture you can see the neck extended pretty high. Try to avoid this as a heavy lens and camera makes the tripod top-heavy and easy to tip over. Adjust the legs if possible and never leave a tripod in an extended neck position alone, too easy to tip over. While this did not cause my accident it is something good to think of when using a tripod. The pan & tilt head was a big part of the problem. I also had the legs fully entended. This tripod has a ‘ball head’ which comes with cheaper tripods(hint, hint). Ball heads have been known to slip even when fully tightened, a heavy lens and camera could then make a tripod out of balance and fall even if you are not around. They can also be stiff to move when trying to adjust a little, like one trichome to the left.
To move the head, you must loosen the ‘tightening nut’. On my tripod the gearing ratio is such that you loosen it seemingly forever then suddenly it is completely loose and the lens pulls the ball head and camera downward and smashes into the tripod legs. That’s part of what happened to me. The other thing was I had to keep moving the lights, plants, and camera so I took the strap off and had to take the camera off the tripod a few times. One of those times reattaching the camera to the tripod I didn’t completely lock the quick release plate to the base plate. It looked locked but it wasn’t. When I loosened the ball head the camera flipped down, hit the tripod leg, that caused to quick release plate(not fully locked) and camera to fly off the camera and smash to the concrete.
Of course, after the fact, I was reminded to always keep your neck strap on or have your camera double strapped to your wrist. Don’t see how I could do that constantly moving plants, lights, tripods, etc. I’ll figure it out. You may notice the camera has a ‘buckle’ neck strap; the neck strap disconnects easily. I was told it is a real handy thing to have. It is. Now I am told that any strap could possibly loosen from the camera, I’ve had that happen. Also, the buckle could unattach or not be buckled securely. Now I have two possible points of strap failure instead of one(sigh)!
Hopefully these tips might help someone save their gear. There was one piece of good news, the SD card was still in the camera and it works! There are thousands of pictures I took over the summer, mostly of the plants. As the highly illustrious
@Mr. Brown once said; ‘You can never look at too many bud pictures’!
From the SD card.
Longball
My wife accused me of being immature. I told her to get out of my fort.