Smokeydraw
New member
Hi everyone,
Am a noobie here so please be gentle. Well finally bit the bullet and got me stock of equipment which comprises:
600 watt (sunmaster dual spectrum)light with Isis reflector and relevant ballast and 1-way contactor.
NFT GT 205 flood and drain
Carbon filter a 4inch exhaust fan
Hesi nutrients
Ph and ec meter
Clip on fan 6inch
Etc
The grow room is a small wardrobe that I am a little unsure what the best approach will be and this is where I need the advice:
Wardrobe is height 1.6m x width 1.2m x depth 0.55m.
I am not able to drill holes in the current structure and also not able to remove the carpet, so first question:
Would you recommend making a grow room within the wardrobe, I was thinking about either using pond liner to make a dark room and cover it with diamond sheeting (already purchased) or
Using some white faced hardboard with some struts for support/strength this would allow me to make a small partition so reducing width to say 1 meter which allow me somewhere to exhaust.
Now the floor. I can't remove the carpet so do I just line it with pond liner and then put diamond sheet ontop (if there is enough I have 5mx1.25m).
OrU
Do I build a small floor to raise everything up a few inches (worried my space is already limited) but if I do raise I could make some inflow holes for air circulation. This is my main concern at the moment.
Again this is where I am getting somewhat confused, am trying to over-complicate the design or am I kind of screwed because I cannot modify the exhisting structure!!
From everything I have read a grow room can almost fit anywhere if you plan it right..............
Once again please help, my budget is almost gone and want to make sure this is not some 2 bit effort that ends up falling flat on its face!!!!!
Thank you in advance for taking the time to read my post, and for any advice you can pass on!
Am a noobie here so please be gentle. Well finally bit the bullet and got me stock of equipment which comprises:
600 watt (sunmaster dual spectrum)light with Isis reflector and relevant ballast and 1-way contactor.
NFT GT 205 flood and drain
Carbon filter a 4inch exhaust fan
Hesi nutrients
Ph and ec meter
Clip on fan 6inch
Etc
The grow room is a small wardrobe that I am a little unsure what the best approach will be and this is where I need the advice:
Wardrobe is height 1.6m x width 1.2m x depth 0.55m.
I am not able to drill holes in the current structure and also not able to remove the carpet, so first question:
Would you recommend making a grow room within the wardrobe, I was thinking about either using pond liner to make a dark room and cover it with diamond sheeting (already purchased) or
Using some white faced hardboard with some struts for support/strength this would allow me to make a small partition so reducing width to say 1 meter which allow me somewhere to exhaust.
Now the floor. I can't remove the carpet so do I just line it with pond liner and then put diamond sheet ontop (if there is enough I have 5mx1.25m).
OrU
Do I build a small floor to raise everything up a few inches (worried my space is already limited) but if I do raise I could make some inflow holes for air circulation. This is my main concern at the moment.
Again this is where I am getting somewhat confused, am trying to over-complicate the design or am I kind of screwed because I cannot modify the exhisting structure!!
From everything I have read a grow room can almost fit anywhere if you plan it right..............
Once again please help, my budget is almost gone and want to make sure this is not some 2 bit effort that ends up falling flat on its face!!!!!
Thank you in advance for taking the time to read my post, and for any advice you can pass on!