Cannatrol Cure Cool System

I have contacted them when I was using their method and they said they have gotten good feedback but they also said hash is completely different than flower so they couldn’t recommend any other settings except for default.



My experience is very limited so I could be wrong.
I think they suggest layers because layers can be stored long term in the device but sift would completely oxidize in sand form.
Every sand particle would be completely oxidized on the surface and probably ruin the quality is my guess.

I don’t store hash once dry in the device.I put the layers in sealed glass jars in a cool place.Sift I put in glass and freeze.


I think for drying the device works very good but only if it’s sifted.

This batch is looking very good. I put a tiny pinch of material between two pieces of parchment.
Even though it felt like hard sand it melted between my fingers within seconds.

I took a magnifying picture of the dot that melted between fingers the trich heads are visible.Those are from the 45 micron bag.








IMG_0607.jpeg I contacted IMG_0605.jpegthem whenIMG_0604.jpeg
 
The batch is dry and I have sifted it 3-4 times.
I’ll wait until 48 hours passes until I seal it up in jars and freeze it.
Here’s a few pictures of the final form before jarring up and freezing.




IMG_0533.jpegIMG_0534.jpeg
IMG_0531.jpeg
 
I am getting a glass hash pipe and I think the one pictured below will work good for hash.

Has anyone used this type?
It’s called Glenn’s briar vented glass hash pipe. The fire stick is made from quartz.


IMG_0603.jpg
 
Last edited:
I am getting a glass hash pipe and I think the one pictured below will work good for hash.

Has anyone used this type?
It’s called Glenn’s briar vented glass hash pipe. The fire stick is made from quartz.


View attachment 96680

I don’t recommend this pipe.
I might be doing something wrong but there are others who can’t get it to work with temple ball or bubble hash.
 
Roll a small amount into a thin snake. Then coil it up like a flat snail shell so you can get airflow through the centre. Make sure it’s small enough to fit in there and not to big that it’s hard to smoke.
Or put a little weed in the bottom as a ‘screen’ then crumble a bit on top and light away. Throw the stick away just use a lighter. Small hits until it gets smoking then you are away.
 
I don’t recommend this pipe.
I might be doing something wrong but there are others who can’t get it to work with temple ball or bubble hash.
Is it the type of hash pipe with 3 holes on the side and an indent in the middle you are supposed to put the hash then a hot "wand" onto? If so, I have a gandalf style which I never got my bubble to work very well as it is intended for 5⭐️full melt.
 
Is it the type of hash pipe with 3 holes on the side and an indent in the middle you are supposed to put the hash then a hot "wand" onto? If so, I have a gandalf style which I never got my bubble to work very well as it is intended for 5⭐️full melt.
Yes same basic design except I got a Glenn’s hash pipe but it doesn’t work with hash??
I should have done more research before I ordered it.
 
Yes same basic design except I got a Glenn’s hash pipe but it doesn’t work with hash??
I should have done more research before I ordered it.
Same, I should have read more before I bought mine. Hash will work, but not very well. Apparently they work much better with dabs or full melt bubble. I can't comment on your hash. But mine, though tasty, is no where near full melt.
 
Back
Top